Getting Started
(2) Load the receipt roll (without I-Mark).
(3) Press the FEED button and release it.
(4) Close the media compartment cover, the LED3 flashes
green 3 times. The MP3200(BT) will feed about 16 cm
receipt paper and remain ready for the next printing. The
MP3200(BT) will give two beeps, the LED1 and LED2 will
light up orange and green respectively.
(5) Press “FEED” button, the LED1 of MP3200(BT) will flash
green(red) at 2 seconds intervals.
(6) The MP3200(BT ) is now ready for standard mode operation.
Verify MP3200 is Working After fully charging the battery pack and loading the receipt roll,
you can print a configuration message to verify MP3200(BT) is
in proper working condition. A configuration message will be
printed after executing the self-test procedure.
(1) Make sure the MP3200(BT) is power off.
(2) Press FEED button and POWER button simultaneously.
(3) Release both POWER and FEED buttons. The LEDs will
flash 5 times to indicate the battery status firstly, then the
LED1 gives short orange blinks 10 times. The MP3200(BT)
will start printing a configuration message.
(4) Pull one edge of the receipt paper against the tear bar to
tear the configuration message down.
This message provides related information on firmware version,
communications, power management, printer control setting,
general specifications and head resistance.
10
MP3200 User’s Guide