Cisco Systems 10000 Series specifications 10-2

Chapter 10 1-Port Gigabit Ethernet Half-Height Line Card Overview

Line Card Summary

Table 10-1	1-Port Gigabit Ethernet Half-Height Line Card Summary(continued)
Product Number		Description	Minimum Cisco IOS Release
ESR-HH-COVER=		Blank filler for half-height line cards	—
SFP-GE-T=		1000BASE-T pluggable transceiver for	12.2(31)SB6 and later releases of Cisco IOS 12.2SB6
		Category 5 copper wire
SFP-GE-S=		1000BASE-SX pluggable transceiver	—
(previously
GLC-SX-MM=)
SFP-GE-L=		1000BASE-LX pluggable transceiver	—
(previously
GLC-LH-SM=)
GLC-ZX-SM=		1000BASE-ZX pluggable transceiver	—
(previously
ESR-SFP-ZX=)
CWDM-SFP-1470		Longwave 1470 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color: Gray
CWDM-SFP-1490		Longwave 1490 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color: Violet
CWDM-SFP-1510		Longwave 1510 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color Identifier: Blue
CWDM-SFP-1530		Longwave 1530 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color Identifier: Green
CWDM-SFP-1550		Longwave 1550 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color Identifier: Yellow
CWDM-SFP-1570		Longwave 1570 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color Identifier: Orange
CWDM-SFP-1590		Longwave 1590 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color Identifier: Red
CWDM-SFP-1610		Longwave 1610 nm laser, single mode	12.2(28)SB1 and later releases of Cisco IOS 12.2SB
		Color Identifier: Brown

The 1-port Gigabit Ethernet half-height line card:

•Contains one Gigabit Ethernet port that provides a trunk uplink to switches and core routers

•Provides the Cisco 10000 series with an IEEE 802.3z-compliant Ethernet interface that can run up to 1 Gbps in full duplex mode.

Note Bandwidth can reach a theoretical maximum of 711 Mbps due to backplane limitations of the PRE-1 (Part Number ESR-PRE1). The backplane bandwidth is not a limitation when using the PRE-2

(Part Number ESR-PRE2) or future PREs.

You install this line card in a Cisco 10000 chassis half-height slot carrier, which you must first install in the Cisco 10000 chassis slot. You can run this line card with a second line card in the other subslot.

Cisco 10000 Series Routers Line Card Hardware Installation Guide

10-2 OL-6773-04