Cisco Systems 100 Series Declaration of Conformity, Conformit Europenne (CE) Marking Directive, European Union Statements

Regulatory Compliance and Safety Information for Cisco SB 100 Series Routers

78-16777-01

Declaration of Conformity

“These ports do not provide isolation sufficient to satisfy the requirement of EN 41003; apparatus

connected to these ports should either have been approved to EN 41003 or have previously been

evaluated against B5E301 British Telecommunications plc (Post Office) Technical Guides 2 or 26

and given permission to attach; any that other usage will invalidate any approval given to this

apparatus.”

Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply

with EN 41003:1993.

•This apparatus must be connected to a main socket outlet with a protective earth contact.

•Connection of power supply: The router is intended for use when supplied with power from a supply

providing 100 to 250 VAC, 50 to 60 Hz up to 0.5A.

Declaration of Conformity

The Declaration of Conformity related to this product is located at the following URL:

http://www.cisco-compliance.com/compliance.asp

This product bears the CE mark in conformance with Annex VII of Directive 1999/5/CE.

The following statements apply to routers used in the European Union (EU).

This product does not contain a “Network Termination Point” (NTP) as defined by ETSI 300 386-2. This

product is classified by the manufacturer as “Terminal Equipment.” If you have any additional questions,

please contact your local network operator.

These ports have not been classified as “directly connected ports” to outside cables as defined by

CISPR 24, 1997 by the manufacturer. If you have any additional questions, please contact your local

network operator.