Chapter 3 Configuring the Cisco 1604 Router
Step
Step 3 Verify that the correct dialer map exists:
Static dialer map ip 10.1.254.1 name
Step 4 Ping the IP address assigned to the Cisco AS5300’s dialer interface. Note that the Cisco 1604
Sending 5,
.!!!!
Success rate is 80 percent (4/5),
The following comments apply to the debug output example that follows:
a.See 08:03:55.
The source and destination IP addresses of the DDR dial cause display. (s=10.1.254.4, d=10.1.254.1)
b.See 08:03:55.
c.See 08:03:55.
ISDN Setup is transmitted.
(TX
d.See 08:03:55.
A synchronous data bearer capability displays. (Bearer Capability i = 0x8890)
e.See 08:03:55.
The outgoing LCP configuration request is made. (BR0:1 LCP: O CONFREQ [Closed] id 42 len 28)
f.See 08:03:55.
The incoming LCP configuration request wants to authenticate with CHAP. (AuthProto CHAP (0x0305C22305))
g.See 08:03:55.
The outgoing acknowledgment says this peer will do CHAP. (LCP: O CONFACK [REQsent])
h.See 08:03:55.
Both PPP peers have received LCP CONFACK. LCP is now open. (BR0:1 LCP: State is Open)
i.See 08:03:55.
Authentication phase is initiated by
(BR0:1 PPP: Phase is AUTHENTICATING, by the peer)
j.See 08:03:55.
(BR0:1 CHAP: I CHALLENGE id 5 len 31 from
(BR0:1 CHAP: O RESPONSE id 5 len 32 from
Cisco IOS Dial Services Quick Configuration Guide