Chapter 3 Configuring the Cisco 1604 Router
Overview of Steps
Overview of Steps
After you verify your start up configuration, follow these steps to configure the router:
Step
Step
Step
Step
Step
Step
Step
Step
Verifying Your Start Up Configuration
If the startup configuration of the Cisco IOS software release running inside the Cisco 1604 router is not configured, the following screen appears at bootup. The automatic setup script is engaged:
In this case study, the Cisco 1604 is manually configured. The automatic setup script is not used.
System Bootstrap, Version 11.1(7)AX [kuong (7)AX], RELEASE SOFTWARE (fc1)
Copyright (c)
C1600 processor with 2048 Kbytes of main memory
program load complete, entry point: 0x4018060, size: 0x1da928
Notice: NVRAM invalid, possibly due to write erase.
complete, entry point: 0x8000060, size: 0x3f5f2c
Restricted Rights Legend
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph
(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec.
(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software
Copyright (c)
Compiled Tue
Image
ROM: System Bootstrap, Version 11.1(10)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
Router uptime is 10 minutes
System restarted by reload
System image file is
Cisco IOS Dial Services Quick Configuration Guide