Cisco Systems 1805 manual Locating Modules

Models: 1805

1 12

Page 4

Chapter 8 Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers

Modules Internal to the Cisco 1805 Cable Router

Figure 8-3 Removing the Cover of the Cisco 1805 Router

HWICL-E-D-2

CAB

CABLE

DS	LINK
US	POWER

ONLINE

232510

	1	Slide cover back from router chassis	2	Rotate cover to remove from router chassis

Step 7	Place the router bottom on an antistatic mat, and begin installing the memory modules.

Figure 8-4shows where the connector for the SODIMM or the AIM is located on the Cisco 1805 cable router motherboard.

Cisco 1805 DOCSIS Cable Router Hardware Installation Guide

8-4	OL-14661-01

Image 4

Contents

Safety Warnings Safety Warnings, pageModules Internal to the Cisco 1805 Cable Router, page Installing and Upgrading Internal Modules in Cisco 1805 Cable RoutersInstalling a SODIMM, page Installing an AIM, page Modules Internal to the Cisco 1805 Cable RouterOpening the Chassis Opening the Chassis, page Locating Modules, pageRouter cover fastening screw Locating Modules Installing a SODIMM Figure 8-4 Cisco 1805 Cable Router Internal ViewFigure 8-6 Installing a SODIMM Installing an AIMFigure 8-5 Removing a SODIMM Installation Procedure Accessory Kit to UseFigure 8-7 Location of Metal Standoff Attachment Locations AIM end Figure 8-8 Plastic Standoff OrientationLocking end Figure 8-9 Connecting the AIM to the System Board AIM Snap-in plastic standoff Metal standoffsApplying the AIM Label Closing the Chassis8-10 8-11 Cisco 1805 DOCSIS Cable Router Hardware Installation GuidePOWER Figure 8-11 Closing the Chassis8-12 Cisco 1805 DOCSIS Cable Router Hardware Installation GuideModules Internal to the Cisco 1805 Cable Router OL-14661-01