Cisco Systems 2500 Series manual Replacing the Cover

Replacing the Cover

Figure 6 Installing the Screw

Input: 100-240VAC

Freq: 50/60 Hz

Current: 1.2-0.6A

Watts: 40W

1

0

H9079

Screw

Step 3 Connect the power connector from the system board. Grasp the sides of the power connector and gently push downward while rocking the connector side to side. (See Figure 7.)

Figure 7 Connecting the Power Connector

AC power supply

Fan

H9247

Power connector

Fan connector

Replacing the Cover

Take the following steps to replace the cover:

Step 1 Position the two chassis sections, as shown in Figure 8.

Step 2 Referring to Figure 8, press the two chassis sections together and ensure the following:

•The top section fits into the rear of the bottom section. (See A in Figure 8.)

•The bottom section fits into the front of the top section. (See B in Figure 8.)

•Each side of the top and bottom sections fits together. (See C in Figure 8.)

6Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers