Chapter3 Installing the Switch
Installing the Catalyst 2948G and 2980G Switches
3-6
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
78-6286-05
Installing the Catalyst 2948G and 2980G SwitchesA standard rack-mount kit is included for mounting the sw itch in a
standard 19-inch (48.3 cm) equipment rack with two unobstructed outer posts.
This kit is not suitable for racks with obstructions (such as a power strip) that
could impair access to theswitch.
Required Installation Tools
You will need the following tools and equipment to install the switch chassis in a
rack:
•Rack-mount kit
•Tape measure and level
•Number 1 Phillips, number 2 Phillips, or a 3/16-inch flat-blade screwdriver
•Antistatic mat or antistatic foam
•Your own electrostatic discharge (ESD) grounding strap or the disposable
ESD strap included with the switch
Note For more information about ESD, refer to the Site Preparation and Safety Guide.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in t he r ack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
Statement 1006