3-17
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
78-6286-05
Chapter3 Installing the Switch Installing the Catalyst 2948G-GE-TX Switch
Attaching the RPS Connector Cover
If you are not using a Cisco RPS with your switch, use the two Phillips pan-head
screws to attach the RPS connector cover to the back of the switch before you
mount it, as shown in Figure 3-13.
Warning
If an RPS is not connected to the switch, install an RPS connector cover on the
back of the switch.
Statement 265
Figure3-13 Attaching the RPS Connector Cover on the Catalyst 2948G-GE-TX
Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in Figur e 3-14.
1Phillips pan-head screws 3RPS connector
2RPS connector cover

1 2

RATING
100-200V ~
1.6A-0>9A, 50-60 HZ
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+12v @8.5a
98668

3