Chapter4 Configuring the Gigabit Ethernet Ports
Connecting To an SFP Module
4-12
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
78-6286-05
Figure4-6 Patch Cord Installation
Connecting To an SFP Module
This section describes how to connect to an SFP module. For instructions about
how to install or remove an SFP module, refer to the Cisco Small Form-Factor
Pluggable Modules Installation Notes (not orderable but is available on
Cisco.com) and to the documentation that came with your SFP module.
Table 4 -4 lists the SFP modules supported by the Catalyst 2948G-GE-TX switch.
To equipment To cable plant
13089
Table4-4 Supported SFP Modules
SFP Type Model Number
Fiber-optic 1000BASE-LX GLC-LS-SM=
Fiber-optic 1000BASE-SX GLC-SX-MM=
Fiber-optic 1000BASE-ZX GLC-ZX-SM=
Copper 1000BASE-T GLC-T=
Coarse Wave Division Multiplexing
(CWDM) fiber-optic SFP modules CWDM-SFP-1470=
CWDM-SFP-1490=
CWDM-SFP-1510=
CWDM-SFP-1530=
CWDM-SFP-1550=
CWDM-SFP-1570=
CWDM-SFP-1590=
CWDM-SFP-1610=