Cisco Systems 2950, 2955 Setting the Interface Speed and Duplex Parameters on a Non-LRE Switch Port, Setting the Interface Speed and Duplex Parameters on an LRE Switch Port

10-12
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 10 Configuring Interface Characteristics
Configuring Ethernet Interfaces
Setting the Interface Speed and Duplex Parameters on a Non-LRE Switch Port
Beginning in priv ileged EXEC mod e, follow these st eps to set the speed and duplex mode for a physical
interface on a non-LRE switch:
Use the no speed and no duplex interface configuration commands to return the interface to the default
speed and duplex settings (autonegotiate). To return all interface settings to the defaults, use the default
interface interface-id interface configuration command.
This example shows how to set the interface speed to 10 Mbps and the duplex mode to half on a port:
Switch# configure terminal
Switch(config)# interface fastethernet0/3
Switch(config-if)# speed 10
Switch(config-if)# duplex half
Switch(config)# end
Setting the Interface Speed and Duplex Parameters on an LRE Switch Port
Beginning in privileged EXEC mode, follow these steps to set the speed and duplex mode for an LRE
interface on an LRE switch:
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Enter interface configuration mode and the physical interface
identification.
Step 3 speed {10 | 100 | 1000 | auto [10 | 100 |
1000] | nonegotiate}
Enter the appropriate speed parameter for the interface, or enter auto
or nonegotiate.
If you use the 10, 100, or 1000 keywords with the auto keyword, the
port only autonegotiates at the specified speeds.
Note The 1000 keyword is available only for 10/100/1000 Mbps
ports. 100BASE-FX ports operate only at 100 Mbps.
1000BASE-SX ports and GBIC module ports operate only at
1000 Mbps. The nonegotiate keyword is available only for
1000BASE-SX, -LX, and -ZX GBIC ports.
Step 4 duplex {auto | full | half}Enter the duplex parameter for the interface. For configuration
guidelines, see the “Configuration Guidelines” section on page 10-10.
Note The duplex keyword is not available on GBIC ports.
Step 5 end Return to privileged EXEC mode.
Step 6 show interfaces interface-id Display the interface speed and duplex mode configuration.
Step 7 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Enter interface configuration mode and the physical interface
identification.
Step 3 local speed {10 | 100}Enter the appropriate speed parameter for the interface.