Cisco Systems 2950, 2955 Shutting Down and Restarting the Interface

10-17
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 10 Configuring Interface Characteristics
Monitoring and Maintaining the Interfaces
To clear the interface counters shown by the show interfaces privileged EXEC command, use the clear
counters privileged EXEC command. The clear counters command clears all current interface counters
from the interface unless optional arguments are specified to clear only a specific interface type from a
specific interface number.
Note The clear counters privileged EXEC command does not clear counters retrieved by using Simple
Network Management Protocol (SNMP), but only those seen with the show interfaces privileged EXEC
command output.
This example shows how to clear and reset the counters on a port:
Switch# clear counters fastethernet0/5
Clear "show interface" counters on this interface [confirm] y
Switch#
*Sep 30 08:42:55: %CLEAR-5-COUNTERS: Clear counter on interface FastEthernet0/5
by vty1 (171.69.115.10)
Use the clear interface or clear line privileged EXEC command to clear and reset an interface or serial
line. Under most circumstances, you do not need to clear the hardware logic on interfaces or serial lines.
This example shows how to clear and reset a port:
Switch# clear interface fastethernet0/5
Shutting Down and Restarting the Interface
Shutting down an interface disables all functions on the specified interface and marks the interface as
unavailable on all monitoring command displays. This information is communicated to other network
servers through all dynamic routing protocols. The interface is not mentioned in any routing updates.
Beginning in privileged EXEC mode, follow these steps to shut down an interface:
Use the no shutdown interface configuration command to restart the interface.
clear interface interface-id Reset the hardware logic on an interface.
clear line [number | console 0 | vty number]Reset the hardware logic on an asynchronous serial line.
Table 10-3 Clear Commands for Interfaces (continued)
Command Purpose
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface {vlan vlan-id} | {{fastethernet | gigabitethernet}
interface-id} | {port-channel port-channel-number}
Select the interface to be configured.
Step 3 shutdown Shut down an interface.
Step 4 end Return to privileged EXEC mode.
Step 5 show running-config Verify your entry.