Cisco Systems 2950, 2955 Displaying Port-Based Traffic Control Settings

21-13
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 21 Configuring Port-Based Traffic Control
Displaying Port-Based Traffic Control Settings
Displaying Port-Based Traffic Control Settings
The show interfaces interface-id switchport privileged EXEC command displays (among other
characteristics) the interface traffic suppression and control configuration. The show storm-control and
show port-security privileged EXEC commands display those features.
To display traffic control information, use one or more of the privileged EXEC commands in Table 21-4.
Tab l e 21-4 Commands for Displaying Traffic Control Status and Configuration
Command Purpose
show interfaces [interface-id] switchport Displays the administrative and operational status of all switching
(nonrouting) ports or the specified port, including port blocking and
port protection settings.
show storm-control [interface-id] [broadcast |
multicast | unicast]
Displays storm control suppression levels set on all interfaces or the
specified interface for the specified traffic type or for broadcast traffic
if no traffic type is entered.
show port-security [interface interface-id]Displays port security settings for the switch or for the specified
interface, including the maximum allowed number of secure MAC
addresses for each interface, the number of secure MAC addresses on
the interface, the number of security violations that have occurred, and
the violation mode.
show port-security [interface interface-id] address Displays all secure MAC addresses configured on all switch interfaces
or on a specified interface with aging information for each address.