12-13
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 12 Configuring LRE
Configuring LRE Ports
To delete the profile from a sequence, use the no profile profile-name interface configuration command.
To display the LRE link statistics and profile information on the LRE ports, use the show controllers
lre privileged EXEC command.
Assigning a Global Sequence to All LRE Ports
Global sequences are set on a switch-wide basis. If you assign a global sequence to the switch, it
overrides any previously or subsequently set profiles. For more information on sequence and profile
precendence, see the “Guidelines for Using LRE Profiles” section on page 12-10.
Changes to the global sequence settings are immediately put in effect, and the global mode automatically
becomes the active mode.
Beginning in privileged EXEC mode, follow these steps to assign a global sequence to the LRE ports:
To delete the assigned sequence, use the no lre rate selection sequence sequence-name global
configuration command.
To display the LRE link statistics and sequence information on the LRE ports, use the show controllers
lre status sequence details privileged EXEC command.
Assigning a Sequence to a Specific LRE Port
You can set sequences on a per-port basis. You can assign the same sequence or different sequences to
the LRE ports on the switch. If you assign a sequence on a per-port basis, it overrides any previously or
subsequently set profiles or global sequence.
The switch resets the ports with the updated sequence settings when they are changed.
Beginning in privileged EXEC mode, follow these steps to assign a sequence to a specific LRE port:
Step 4 end Return to privileged EXEC mode.
Step 5 show controllers lre profile details Verify the change.
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 lre rate selection sequence sequence-name Enter the global sequence name. Select from the list in Table 12-3 o n
page 12-5 and Table 12-4 on page 12-5.
Step 3 end Return to privileged EXEC mode.
Step 4 show controllers lre status sequence Verify the change.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.