Cisco Systems 3700

Installation Summary

Installing the access point involves these operations:

•Performing a pre-installation configuration (optional)

•Mounting the access point

•Grounding the access point

•Deploying the access point on the wireless network

Performing a Pre-Installation Configuration

The following procedures ensure that your access point installation and initial operation go as

expected. A pre-installation configuration is also known as priming the access point. This procedure

is optional.

Note Performing a pre-installation configuration is an optional procedure. If your network

controller is properly configured, you can install your access point in its final location and

connect it to the network from there. See the “Deploying the Access Point on the Wireless

Network” section on page 17 for details.

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in Figure 4.

Contents

Main GETTING STARTED GUIDE Cisco Aironet 3700 Series Access Points Page 1 2 3 Page 4 5 External Antennas Internal Antennas Regulatory Domains Page 6 Page 7 The Controller Discovery Process Page Preparing the Access Point Page Page Page 8 9 10 11 Guidelines for Using Cisco Aironet Lightweight Access Points Using DHCP Option 43 Checking the Access Point LED Page Message Type Status LED Message Meaning Troubleshooting the Access Point Join Process Page 12 Manufacturers Federal Communication Commission Declaration of Conformity Statement Access Point Models Certification Number Module Models Certification Number Tested To Comply With FCC Standards FOR HOME OR OFFICE USE Page Page Guidelines for Operating Cisco Aironet Access Points in Japan Japanese Translation 03-6434-6500 Statement 371Power Cable and AC Adapter Industry Canada Canadian Compliance Statement Access Point Models Certification Number Module Models Certification Number French Translation European Community, Switzerland, Norway, Iceland, and Liechtenstein Access Point Models: Page Page Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets International Guidelines for Exposure to Radio Waves This Device Meets FCC Guidelines for Exposure to Radio Waves This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves Separation Distance MPE Distance Limit 0.63 mW/cm220 cm (7.87 inches) 1.00 mW/cm2 Additional Information on RF Exposure Distance d'loignement MPE Distance Limite 0.63 mW/cm220 cm (7.87 po) 1.00 mW/cm2 Page Chinese Translation Operation of Cisco Aironet Access Points in Brazil Regulatory Information Portuguese Translation Declaration of Conformity Statements 13 To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps: