Cisco Systems manual Reloading the Switch Router, 3-16

Chapter 3 Initial Switch Router Configurations

Updating the System Image

Verifying checksum... OK (0x799F)

3173128 bytes copied in 177.668 secs (17927 bytes/sec) Router# dir bootflash:

Directory of bootflash:/

1 -rw- 3173128<no date> cat2948g-in-mz.120-7.W5.14.45

16777216 bytes total (13604024 bytes free) Router# copy tftp: bootflash:

Address or name of remote host [172.10.00.00]?

Source filename [domino/cat2948g-in-mz.120-7.W5.14.45]? domino/cat2948g-in-mz.120-7.W5.14.46

Destination filename [cat2948g-in-mz.120-7.W5.14.46]?

Accessing tftp://172.10.00.00/domino/cat2948g-in-mz.120-7.W5.14.46...

Erase bootflash: before copying? [confirm] no

Loading domino/cat2948g-in-mz.120-7.W5.14.46 from 172.10.00.00 (via FastEthernet 1): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!

!

[OK - 3173364/6345728 bytes]

Verifying checksum... OK (0x755F)

3173364 bytes copied in 210.364 secs (15111 bytes/sec) Router# dir bootflash:

Directory of bootflash:/

1	-rw-	3173128	<no	date>	cat2948g-in-mz.120-7.W5.14.45
2	-rw-	3173364	<no	date>	cat2948g-in-mz.120-7.W5.14.46

16777216 bytes total (10430596 bytes free)

Note Make sure that the file size of the image file you copied to boot flash memory matches the image file size on the server.

Reloading the Switch Router

When the configuration register is set for manual booting, issuing the reload command causes the system to enter ROM monitor mode, where you enter the boot command and the name of the system image to use. To perform this procedure, you must be connected to the console port, which provides access to the switch router when in ROM monitor mode. For automatic booting, you can issue the reload command from an Ethernet connection to the route processor.

Note This procedure assumes that you need to change the boot field in the configuration register from its default value so that the system reverts to ROM monitor mode when you issue the reload command.

	Catalyst 2948G-L3 and Catalyst 4908G-L3 Software Feature and Configuration Guide
3-16	78-10408-01, Cisco IOS Release 12.0(7)W5(15d)