Send documentation comments to nexus5kdocs@cisco.com.
3-4
Cisco Nexus 6000 Series Hardware Installation Guide
OL-15902-01
Chapter3 Connectin g the Switch
Connecting to an Ethernet Port
Step 2 Remove the dust cover from the port cage.
Step 3 Remove the dust cover from the port end of the transceiver.
Step 4 Insert the transceiver into the port as follows:
•If the transceiver has a Mylar tab latch, position the transceiver with the tab on the bottom, and then
gently insert the transceiver into the port until it clicks into place.
•If the transceiver has a bale clasp latch, position the transceiver with the clasp on the bottom, close
the clasp by pushing it up over the transceiver, and then gently insert the transceiver into the port
until it clicks into place.
Caution If the transceiver does not install easily, ensure that it is correctly positioned and the tab or
clasp are in the correct position before continuing.
Note If you cannot install the cable into the transceiver, insert or leave the dust plug in the cable end
of the transceiver.
Replacing a Transceiver To replace a transceiver, follow these steps:
Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2 If a cable is installed in the transceiver, do the following:
a. Record the cable and port connections for later reference.
b. Press the release latch on the cable, grasp the connector near the connection point, and gently pull
the connector from the transceiver.
c. Insert a dust plug into the cable end of the transceiver.
Caution If the transceiver does not remove easily in the next step, push the transceiver completely in
and then ensure that the latch is in the correct position before continuing.
Step 3 Remove the transceiver from the port as follows:
•If the transceiver has a Mylar tab latch, gently pull the tab straight out (do not twist), and then pull
the transceiver out of the port.
•If the transceiver has a bale clasp latch, open the clasp by pressing it downward, and then pull the
transceiver out of the port.
Note If you have difficulty removing a bale clasp transceiver , you should reseat it by returning the bale
clasp latch to the up position. Press the transceiver inward and upward into the cage. Next, lower
the bale clasp latch and pull the transceiver straight out with a slight upward lifting force. Be
careful not to damage the port cage during this process.