Cisco Systems N6KC600496Q, N6004SBUNP1L manual Connecting the Switch Connecting to an Ethernet Port

Chapter 3 Connecting the Switch

Connecting to an Ethernet Port

Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .

Caution If the cable does not remove easily, ensure that any latch present on the cable has been released before continuing.

To remove the cable, follow these steps:

Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.

Step 2 Press the release latch on the cable, grasp the connector near the connection point, and gently pull the connector from the transceiver.

Step 3 Either install a replacement cable in the transceiver (see the “Installing a Cable into an Transceiver” section on page 3-5) or insert dust plugs into the cable end of the transceiver and the end of the removed cable.

Cisco Nexus 6000 Series Hardware Installation Guide

3-6 OL-15902-01