Chapter 2 Installing the Cisco Nexus 6000 Series Switches
Starting the Switch
Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .
Warning
Caution
Caution
Warning
Caution
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046
We recommend grounding the chassis, even if the rack is already grounded.
All power supplies must be grounded. The receptacles of the AC power cables used to provide power to the chassis must be the grounding type, and the grounding conductors should connect to protective earth ground at the service equipment.
When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Grounding the chassis is required if you are using DC power supplies, even if the rack is already grounded. A grounding pad with two threaded M4 holes is provided on the chassis for attaching a grounding lug. The ground lug must be NRTL listed. In addition, the copper conductor (wires) must be used and the copper conductor must comply with NEC code for ampacity.
To attach the grounding lug and cable to the chassis, follow these steps:
Use a
Insert the stripped end of the grounding cable into the open end of the grounding lug.
Use the crimping tool to secure the grounding cable in the grounding lug.
Remove the adhesive label from the grounding pad on the chassis.
Place the grounding lug against the grounding pad so that there is solid
Ensure that the lug and cable do not interfere with other equipment.
Prepare the other end of the grounding cable and connect it to an appropriate grounding point in your site to ensure adequate earth ground.
Starting the Switch
This section provides instructions for powering up the Cisco Nexus 6004 switch and verifying the component installation.
| Cisco Nexus 6000 Series Hardware Installation Guide |
|
