![](/images/new-backgrounds/1168492/16849233x1.webp)
Chassis Ground Connection Installation
Figure 12 Attaching the Grounding Lug and Wire to the Chassis
3
1
2
42
50536
| 1 |
|
|
Chassis ground connector |
| Screws | |
| 3 | ||
Grounding lug |
| 4 | Wire |
|
|
|
|
Note The grounding lug and Phillips screws are not available from Cisco Systems. Get the grounding lug from an
Step 1 Locate the chassis ground connector (1) on the rear of your router chassis.
Step 2 Use the wire stripper to strip one end of the
Step 4 Use the crimping tool to carefully crimp the wire receptacle around the wire; this step is required to ensure a proper mechanical connection.
Step 5 Insert the two screws (3) through the holes in the grounding lug (2).
Step 6 Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the chassis. Do not overtighten the screws.
Step 7 Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate chassis ground.
17