Cisco Systems 78-11180-01 manual PIX Firewall then displays the following messages

Chapter 2 Installing a PIX Firewall

Startup Messages

If you have an activation key that supports encryption, the following statement appears:

****************************** Warning *******************************

Compliance with U.S. Export Laws and Regulations - Encryption.

This product performs encryption and is regulated for export by the U.S. Government.

This product is not authorized for use by persons located outside the United States and Canada that do not have prior approval from Cisco Systems, Inc. or the U.S. Government.

This product may not be exported outside the U.S. and Canada either by physical or electronic means without PRIOR approval of Cisco Systems, Inc. or the U.S. Government.

Persons outside the U.S. and Canada may not re-export, resell or transfer this product by either physical or electronic means without prior approval of Cisco Systems, Inc. or the U.S. Government.

******************************* Warning *******************************

PIX Firewall then displays the following messages:

The 'logging trap' command now sets only the syslog server logging level.

Use the 'logging history' command to set the SNMP logging level.

Cryptochecksum(unchanged): 29bd47de e4c13958 db57ee04 282ae9de

Copyright (c) 1996-2000 by Cisco Systems, Inc.

Restricted Rights Legend

Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph

(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph

(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013.

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Type help or '?' for a list of available commands. pixfirewall> enable

Enter the enable command to start unprivileged mode. You are then prompted for the enable password as follows:

Password:

Unless you have assigned a value to the enable password, which you can do with the enable password command, press the Enter key to signify the default of no password. You are now in unprivileged mode.

Start configuration mode by entering the configure terminal command:

pixfirewall# configure terminal

pixfirewall(config)#

You are now ready to start configuring your PIX Firewall, which is described in the following sections and in the Cisco PIX Firewall Configuration Guide, Version 5.2.

Installation Guide for the Cisco Secure PIX Firewall Version 5.2

78-11180-01 2-25