Cisco Systems 7931G manual Meet-Me Conference Call, Ad Hoc Conference Call

Meet-Me Conference Call

Meet-Me conferencing allows you to start or join a conference by dialing the conference number, and supports up to 32 parties.

To start a Meet-Me conference, use the following method:

1.Obtain a Meet-Me phone number from your system administrator.

2.Distribute the number to participants.

3.Obtain a dial tone, then press the more > MeetMe soft keys.

4.Dial the Meet-Me conference number. Participants can now join the conference by dialing in.

Note You hear a busy tone if you call the conference before the initiator has joined. If this happens, try your call again.

To end a Meet-Me conference, all participants must hang up. The conference does not automatically end when the conference initiator disconnects.

Ad Hoc Conference Call

Ad hoc conferences are created when one party calls another, then either party decides to add another party to the call. This is the default behavior. Your system can be configured so that only the conference creator can add parties to the conference.

The default is that the conference is maintained as long as three parties remain in the conference. Any party can hang up and the conference is maintained. Your system can be configured so that the conference drops when the creator hangs up. Your system can also be configured so that the conference drops when the last local party hangs up.

Ad Hoc conferencing supports up to eight parties.

Start a Conference Call

To add new participants to an existing conference, use the following method:

1.From a connected call, press Confrn. (You may need to press the more soft key to see Confrn.)

2.Enter the participant’s phone number.

3.Wait for the call to connect.

4.Press Confrn again to add the participant to your call.

5.Repeat to add additional participants.

View a List of Participants

To view a list of conference participants, use the following method:

1.Highlight an active conference.

2.Press ConfList. Participants are listed in the order in which they join the conference with the most recent additions at the top.

To get an updated list of participants, while viewing the conference list, press Update.

To see who started the conference, while viewing the conference list, locate the person listed at the bottom of the list with an asterisk (*) next to the name.

To drop the last party added to the conference, press RmLstC. You can remove participants only if you initiated the conference call.

Remove Participants

To remove any conference participant, use the following method:

1.Highlight the participant’s name.

2.Press Remove. You can remove participants only if you initiated the conference. To end your participation in a conference, hang up or press EndCall.

13