Basic Place a Call, Speakerphone Place a Call

•Activate Do Not Disturb, page 16

•Setting and Adjusting Your Cisco Unified IP Phone, page 9

Basic: Place a Call

To place a call, use one of the following methods:

•Lift the handset and dial the number. If you cannot hear a dial tone, choose an available line by pressing the line key.

•Dial the number and then lift the handset.

•Press the line button for your extension, dial the number, and then lift the handset.

•Press any available button, dial the number, and then lift the handset.

•Press the New Call soft key, dial the number, and then lift the handset.

•Press a speed-dial button and then lift the handset.

•If you have selected a number from a directory, press the Dial soft key, and then lift the handset.

To place a call using the speakerphone, use one of the following methods:

•Press the speakerphone button and perform the steps for placing a basic call, and do not lift the handset.

•Perform the steps for placing a basic call and do not lift the handset.

To switch to handset operation, just lift the handset.

To place a call using a headset, press the heasdset button, then perform the steps for placing a basic call, and do not lift the handset.

To switch to handset operation, just lift the handset.

To answer a call, use one of the following methods:

•Lift the handset.

•If you are using a headset, press the line button to select between incoming calls.

•To use the speakerphone, press the line button (flashing amber), the Answer soft key, or the Speaker button.

To end a call, use one of the following methods:

•Hang up the handset.

•If you are using a headset, press the EndCall soft key.

•If you are using the speakerphone, press the Speaker button or the EndCall soft key.

To redial the most recently dialed number, use one of the following methods:

•Lift the handset and press the Redial button.

•Press a line button and then press redial.

•Press the Redial button to dial using the speakerphone.