Cisco Systems 820 Series quick start Connect the Power and Turn On the Router

5: Connect the Power and Turn On the Router

5: Connect the Power and Turn On the Router

Follow the steps in Figure 5 on page 7 to connect an AC adapter to the Cisco router and turn it on. (Figure 5 shows a Cisco 827-4V router, but the process applies to all Cisco 820-series and SOHO routers.)

Caution Be sure to use the power supply that was supplied with your Cisco router. Power supplies for other Cisco routers will not plug in to the power receptacle on the back panel.

After you turn on the router, the OK LED on the front will turn on. After a minute or two, the xDSL CD LED will turn on. The Ethernet LEDs for the Ethernet ports to which you have connected PCs or hubs will turn on a minute or two after you have turned on the PCs.

Figure 5 Connecting the Power to the Router

1. Press power switch to standby ().

Cisco 827-4V router

TO PC	ETHERNET	CONSOLE		Model Cisco
TO HUB					827-4V
			ADSL
	1						PHONE	+5,+12,-
								12,-24,-
									71 VDC
					4	3	2
								1

5. Press power switch to on ( ).

4. Connect power	Desktop power	2. Connect power
		supply cable.
cord to electrical	supply
outlet.
		3. Connect power cord
		to power supply.

65594

1	Press power switch to standby.	4	Desktop power supply
2	Cisco 827-4V router.	5	Connect power cord to electrical outlet.
3	Connect power supply cable.	6	Press power switch to on.
4	Connect power cord to power supply.	7

Cisco 820 Series and SOHO Series Routers Cabling and Setup Quick Start Guide

78-13937-04 7