Cisco Systems 1602I, AIRCAP1602EAK9, AIRCAP1602IAK9, AIRCAP1602IAK910, AIRSAP1602EAK9, AIRSAP1602IAK9, AIRSAP1602IAK95, AIRSAP1602ITK9 Performing a Pre-Installation Configuration, Pre-Installation Configuration Setup

Performing a Pre-Installation Configuration

The following procedures ensure that your access point installation and initial operation go as

expected. A pre-installation configuration is also known as priming the access point. This procedure

is optional.

Note Performing a pre-installation configuration is an optional procedure. If your network

controller is properly configured, you can install your access point in its final location and

connect it to the network from there. See the “Deploying the Access Point on the Wireless

Network” section on page 15 for details.

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in Figure 4.

Figure 4 Pre-Installation Configuration Setup

To perform pre-installation configuration, perform the following steps:

Controller

Layer 3

devices

Cisco Aironet

access points

272488

Contents

Main GETTING STARTED GUIDE Cisco Aironet 1600 Series Access Points 1 2 3 4 5 External Antennas Internal Antennas Regulatory Domains Countries Supported 6 Page Page 7 The Controller Discovery Process 1 Kensington lock slot 4 2 5 3 Gbit Ethernet port 6 Page Preparing the Access Point Installation Summary Performing a Pre-Installation Configuration Pre-Installation Configuration Setup Page Page 8 9 10 Guidelines for Using Cisco Aironet Lightweight Access Points Using DHCP Option 43 Checking the Access Point LED Page Troubleshooting the Access Point Join Process Message Type Status LED Message Meaning Page 11 Manufacturers Federal Communication Commission Declaration of Conformity Statement Models Certification Numbers Page Page Guidelines for Operating Cisco Aironet Access Points in Japan Japanese Translation 03-6434-6500 Statement 371Power Cable and AC Adapter Canadian Compliance Statement Models Certification Numbers European Community, Switzerland, Norway, Iceland, and Liechtenstein Models: Page Page Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets International Guidelines for Exposure to Radio Waves This Device Meets FCC Guidelines for Exposure to Radio Waves This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Separation Distance MPE Distance Limit 0.63 mW/cm220 cm (7.87 inches) 1.00 mW/cm2 Page Chinese Translation Operation of Cisco Aironet Access Points in Brazil Access Point Models Regulatory Information Declaration of Conformity Statements 12 Category Specification in a buildings environmental air handling spaces, such as above suspended ceilings. 13

Cisco Systems Performing a Pre-Installation Configuration, Pre-Installation Configuration Setup

Models: 1602I AIRCAP1602EAK9 AIRCAP1602IAK9 AIRCAP1602IAK910 AIRSAP1602EAK9 AIRSAP1602IAK9 AIRSAP1602IAK95 AIRSAP1602ITK9