Using the Startup Wizard
Note You can use either the
Note The first time that you connect a Windows PC to the USB console port, you are prompted to install the USB console driver. Follow the installation prompts to install the driver. The USB console driver maps to a COM port on your PC; you then need to map the terminal emulator application to the COM port.
See the “USB
Follow these steps to connect the PC to the controller’s console port:
Step 1 If you use the CONSOLE port, plug the
If you use the USB console port, plug the
Step 2 Start the PC’s terminal emulation program.
Step 3 Configure the terminal emulation program for the following parameters:
•9600 baud
•8 data bits
•No flow control
•1 stop bit
•No parity
Using the Startup Wizard
Before you can use the startup wizard, you may need to obtain the information discussed in the “Required Tools and Information” section on page 11. Also, you will need to know the following information:
•Management network interface IP Address
•Wireless management interface IP Address
•VLAN number for the wireless management interface
At any point you may enter a question mark (?) for help. Press
Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system.
To configure the controller for basic operation using the Startup Wizard, follow these steps:
Step 1 When prompted to enter basic management setup, enter yes.
Step 2 Enter the hostname, which is the name you want to assign to the controller.
Cisco 5700 Series Wireless Controller Installation Guide
22 |
| |
|
