Unpacking and Installing the Controller
–
–Null modem serial cable to connect CLI console and controller
•Local TFTP server (required for downloading operating system software updates). Cisco uses an integral TFTP server. This means that
You will need the following tools before you can install the controller:
•#2 Phillips screwdriver for securing the mounting hardware
The following additional items (not found in the accessory kit) are required to ground the chassis:
•Grounding cable (6 AWG recommended), sized according to local and national installation requirements; the required length depends on the proximity of the controller to proper grounding facilities
•Crimping tool large enough to accommodate girth of lug
•
Initial System Configuration Information
Obtain the following initial configuration parameters from your wireless LAN or network administrator:
•A system (controller) name.
•The enable secret password.
•The enable password.
•Virtual terminal password.
•SNMP network management configuration information.
•Management network configuration information.
•NTP server information or current time.
•A Cisco wireless LAN controller mobility group name.
•The country code for this installation. Refer to the Cisco Wireless LAN Controller Configuration Guide for country code information. This guide is available at cisco.com.
•Wireless management interface configuration information.
Choosing a Physical Location
You can install the controller almost anywhere, but it is more secure and reliable if you install it in a secure equipment room or wiring closet. For maximum reliability, mount the controller using the following guidelines:
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of:
104° F (40° C) Statement 1047
Cisco 5700 Series Wireless Controller Installation Guide
12 |
| |
|
