2-11
Cisco Aironet 1000 Series Lightweight Access Point Hardware Installation Guide
OL-9403-04
Chapter2 Installing the Ac cess Point
Mounting Overview
Step7 Attach the cables to the access point.
Note When the access point is powered up and is associated with a controller (Power LED is green,
Alarm LED is off, and the radio LEDs are blinking), the access point is broadcasting its beacon.
Step8 Repeat the these steps for each access point on a horizontal surface.
After mounting all horizontal surface access points, return t o de ploying the access points, "Step 3-c" on
page 2-7.
c
Mounting Access Points Using the Ceiling-Mount Clips
When you are mounting the access point under a suspended ceiling, use the ceilin g-mount clips to mount
the access point to the suspended ceiling rails.
Figure2-8 Attaching the Ceiling-Mount Clips to the Access Point
Follow these steps to attach the ceiling-mount clips to the access point and mount the access point to
suspended ceiling rails:
Step1 Copy the MAC address from the label on the access point onto the corresponding location on the access
point location map. MAC addresses have the format 00xxxxxxxxxx.
Step2 Attach the ceiling-mount clips to the bottom of the access point using the factory-supplied machine
screws and washers (see Figure2-8).
135665