Connect the E1/PRI Card for WAN Access
Warning This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260 Clause 1.2.14.3 Service Personnel.
Warning The telecommunications lines must be disconnected 1) before unplugging the main power connector and/or 2) while the housing is open.
Warning The E1 interface card may only be installed in an
You will need four E1 cables to connect the E1/PRI card to a WAN. The E1 cables and E1 networks terminating units are not included.
Step 1 Connect the
Step 3 Connect the Tx end of the cable to the Transmit port of the E1 networks terminating unit. Step 4 Repeats Steps 1 to 3 to connect other cables to the remaining ports.
E1/PRI card | Universal access |
| server |
E1 cable
E1 networks terminating unit
Rx
Tx
9