Cisco Systems AS5400 Specification, Description, 2 4-Port T1 or E1 DFC, 3 8-Port T1 or E1 DFC

Chapter 3 T1 and E1 Dial Feature Cards

Overview

Figure 3-2 4-Port T1 or E1 DFC

Bantam ports

T1 or E1 ports

					4 PRI
0	1	2	3	Rx Tx	ACT OK/
					MAINT

56023

Figure 3-3 8-Port T1 or E1 DFC

29030

Table 3-1 T1 DFC Network Specifications

Description		Specification
Line rate		1.544 Mbps
Data rates (per port)		number x 56 or number x 64 kbps, where
		number = 1 to 24
Standards		AT&T Pub. 62411, 54016, and 43081,
		and ANSI T1.403
Input impedance		100 ohms per port
Table 3-2 E1 DFC Network Specifications
Description	Specification
Line rate	2.048 Mbps
Data rate (per port)	number x 56 or number x 64 kbps, where number = 1 to 31.
Input impedance	75 or 120 ohms per port
	Note The factory default setting for the E1 ports is 120 ohm. Use a software
		command to change the impedance. Refer to the, Cisco AS5350 and
		Cisco AS5400 Universal Gateway Card Installation Guide.

Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide

3-2 78-13311-01