C H A P T E R 3
Installing the Cisco ASA 5505
Installing the Chassis
This section contains the following topics:
•Connecting the Interface Cables, page 3-1
•Powering on the Cisco ASA 5505, page 3-3
•Installing a Cable Lock, page 3-4
•Rack or Wall Mounting the Cisco ASA 5505, page 3-4
Connecting the Interface Cables
This section describes how to connect the cables to the Ethernet and Console ports.
Warning Only trained and qualified personnel should install, replace, or service this equipment. Statement 49
Caution Read the safety warnings in the Regulatory Compliance and Safety Information for the Cisco ASA 5505 Adaptive Security Appliance and follow proper safety procedures when performing these steps.
To connect cables to the ports perform the following steps:
Step 1 Place the chassis on a flat, stable surface.
Step 2 Before connecting a computer or terminal to the ports, check to determine the baud rate of the serial port. The baud rate must match the default baud rate (9600 baud) of the Console port of the adaptive security appliance. Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow Control (FC) = Hardware.
Step 3 Connect the cables to the ports.
Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
|
| ||
|
|