Cisco Systems ASA5505BUNK9 3-12, 1 M3 x 12 screws, Plastic anchors for vertical mounting optional

Chapter 3 Installing the Cisco ASA 5505

Rack or Wall Mounting the Cisco ASA 5505

Figure 3-10 Bottom View of the FIPS Enclosure

1
	1
2	2
3	3

2	2
	272365
	1
1 M3 x 12 screws	3 Plastic anchors for vertical mounting (optional)

2Plastic anchors

Step 3 Drill a hole on the wall at each mark you made for the location for the plastic anchors. Step 4 Press the four plastic anchors into the holes.

Step 5 Screw the four screws provided in the accessory kit into the anchors, but not all the way. Allow them to protrude about 1/8-inch (0.317 cm).

You must apply three tamper evident labels. Tamper evident labels are inclued in the FIPS kit, Cisco-FIPS-KIT=. Clean the chassis of any grease, dirt, or oil before applying the tamper evident labels. Alcohol-based cleaning pads are recommended for this purpose.

Step 6 Apply the first tamper evident label as shown in Figure 3-11.

Figure 3-11 Cisco ASA 5505 Tamper Evident Label Placement

1
				Security
				Services
				Card Slot
POWER
48VDC
7 POWER over ETHERNET 6	5	4	3	2	1	0

Console

1

RESET

2

250576

1

Tamper label

	Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
3-12	OL-18362-01