Cisco Systems ASA5505K8RF, ASA 5505BUNK9 manual Installing an SSC, Color, State, Description

Chapter 4 Maintenance and Upgrade Procedures

Installing and Replacing the SSC

Table 4-1describes the SSC LEDs.

Table 4-1		SSC LEDs
	LED		Color	State	Description
1	STATUS		Green	Flashing	The system is booting.
				Solid	The system has passed power-up diagnostics.

Installing an SSC

To install a new SSC for the first time, perform the following steps:

Step 1 Power off the adaptive security appliance.

Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare skin. Attach the other end to the chassis.

Step 3 Remove the two screws (as shown in Figure 4-4) at the left rear end of the chassis, and remove the slot cover.

Figure 4-4 Removing the Screws from the Slot Cover

Security

Services

Card Slot

7			Console
	POWER over
	ETHERNET 6	5
		4	1
		3
		2
		1	2
		0		RESET

Step 4 Insert the SSC into the slot opening as shown in Figure 4-5.

Figure 4-5 Inserting the SSC into the Slot

251165

Cisco AS

A SSC-05

STATUS

7	POWER over
	ETHERNET 6

Security

Services

Card Slot

5 4 3 2 1 0

Console

1

2

RESET

251166

Step 5 Attach the screws to secure the SSC to the chassis.

Step 6 Power on the adaptive security appliance.

Step 7 Check the LEDs. If the SSC is installed properly the STATUS LED flashes green.

Step 8 Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices.

Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide

OL-18362-01 4-5