
After you connect to the switch port, the port LED turns amber while the switch establishes a link. This process takes about 30 seconds, and then the LED turns green when the switch and the target device have an established link. If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See the “In Case of Difficulty” section on page 20 for information about online assistance.
6Connecting to DC Power
To connect the Catalyst
Equipment That You Supply
You need to supply these tools and equipment:
•Ratcheting
•Panduit crimping tool
•
•Four leads of
•Wire stripping tool
Ground the Switch
Follow these steps:
Step 1 Remove the ground lug and the two
Step 2 If your
0.5 inch (12.7 mm) 

17