Cisco Systems CGR1120K9 manual Enabling an Interface, Additional WiMAX Configuration Commands

Configuring the Module

Note *—The command, pkm trustpoint device device_cert_trustpoint, is not needed if 1) EAP-TLS is using the embedded Airspan certificate, or 2) if EAP-TTLS is used.

Enabling an Interface

To configure a WiMAX interface, issue the following commands:

Router# configure terminal

Router(config)# interface wimax 2/1

Router(config-if)# shutdown

Router(config-if)# no shutdown

Router(config-if)# end

Router#

Additional WiMAX Configuration Commands

The following are the WiMAX configuration commands:

•(config)# wimax scan-list scan_list_name

•(config-scan-list)#nap id nap-id priority priority channel-index channel-index

•(config-scan-list)#nsp id nsp-id {home priority priority channel-index channel-index}

•(config-if)# [no] wimax pkm-version {pkm-v2}

•(config-if)# [no] shutdown

•(config-if)# [no] ip address {IP_address_in_format_i.i.i.i IP_prefix_and_network_mask_length_in_format_x.x.x.x/m IP_network_mask_in_format_m.m.m.m}

WiMAX show Command Examples

The following are WiMAX related show commands:

•show sprom, page 21

•show interfaces wimax interface_name association, page 22

•show controllers wimax interface_name, page 22

•show interfaces wimax interface_name statistics, page 23

•show interface wimax interface_name scanning, page 23

show sprom

To show the command options for the show sprom command, do the following:

Router# show sprom ?

all	Show all sproms contents
backplane	Show	backplane	clock	module sprom contents
clock	Show	backplane	clock	module sprom contents
	Cisco Connected Grid Modules for CGR 1000 Series—WiMAX Installation and Configuration Guide
OL-26236-03					21