56
Regulatory Compliance and Safety Information for the CiscoAS5400 and Cisco AS5400XM Universal Gateways
OL-10264-01
Canada
Canada
The channelized T3 trunk card meets Canadian requirements for T3 support as specified in CP-01
standards.

Industry Canada Compliance

The following are notices required by Industry Canada Terminal Attachment Program Certification
Procedure CP-01, Part I, Section 14.

Equipment Attachment Limitations

The Industry Canada label identifies certified equipment. This certification means that the equipment
meets certain telecommunications network protective operational and safety requirements. The
Department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing the equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable
method of connection. In some cases, the company’s inside wiring associated with a single line
individual service may be extended by means of a certified connector assembly (telephone extension
cord). The customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Australia
This customer equipment is to be installed and maintained by service personnel as defined by
AS/NZ3260 clause 1.2.14.3 Service Personnel. Incorrect connection of connected equipment to the
General Purpose Outlet could result in a hazardous situation.
Safety requirements are not fulfilled unless the equipment is connected to a wall socket outlet with
protective earth contact.
Europe (EU)
This apparatus complies with EN55022 Class B and EN55024 standards when used as ITE/TTE
equipment, and EN 300 386-2 (with EN55022 class B non-central office equipment) for
Telecommunications Network Equipment (TNE).
The channelized E1 trunk card meets United Kingdom (UK) requirements for E1 support as specified in
607122 standards.