Cisco Systems Cisco ONS 15454 SDH DLP-D64 Set the IP Address, Default Router, and Network Mask Using the LCD

4-13

Cisco ONS 15454 SDH Procedure Guide, R4.6

January 2004

Chapter4 Turn Up Node DLP-D64 Set the IP Address, Default Router, and Network Mask Using the LCD

Step 7 Return to your originating procedure (NTP).

DLP-D64 Set the IP Address, Default Router, and Network Mask Using the LCD

Note Youcannot perform this task if the LCD IP Display on the node view Provisioning > Network tab is set

to Display Only or Suppress Display.See “DLP-D249 Provision IP Settings” task on page 4-10 to view

or change the LCD IP Display field.

Note The LCD reverts to normal display mode after 5 seconds of button inactivity.

Step 1 On the ONS 15454 SDH front panel, repeatedly press the Slot button until Node appears on the LCD.

Step 2 Repeatedly press the Port button until the following displays:

•To change the node IP address, Status=IpAddress (Figure4-1)

•To change the node network mask, Status=Net Mask

•To change the default router IP address, Status=Default Rtr

Figure 4-1 Selecting the IP Address Option

Step 3 Press the Status button to display the node IP address (Figure 4-2), the node subnet mask length, or the

default router IP address.

Purpose This task changes the ONS 15454 SDH IP address, default router, and

network mask using the front panel LCD. Use this task if you cannot log

into CTC.

Tools/Equipment None

Prerequisite Procedures DLP-D332 Install the TCC2 Cards, page 2-7

Required/As Needed As needed

Onsite/Remote Onsite

Security Level None

FAN FAIL

Slot

44089

CRIT MAJ MIN

Status Port