4-32
Cisco ONS 15454 SDH Procedure Guide, R4.6
January 2004
Chapter4 Turn Up Node
NTP-D34 Set Up SNMP
Step 5 From the Available Ports list, choose the port that will be protected by the port you selected in Protect
Ports. Click the top arrow button to move each port to the Working Ports list.
Step 6 Complete the remaining fields:
•Revertive—Select this check box if you want traffic to revert to the working port after failure
conditions remain corrected for the amount of time entered in the Reversion Time field.
•Reversion time—If Revertive is checked, select a reversion time from the drop-down menu. The
range is 0.5 to 12.0 minutes. The default is 5.0 minutes. Reversion time is the amount of time that
will elapse before the traffic reverts to the working card after conditions causing the switch are
cleared.
Step 7 Click OK.
Step 8 Return to your originating procedure (NTP).
NTP-D34 Set Up SNMP
Step 1 Complete the “DLP-D60 Log into CTC” task on page 3-24 at the node where you want to set up SNMP.
If you are already logged in, continue with Step 2.
Step 2 In node view, click theProvisioning > SNMP tabs.
Step 3 If you wantthe SNMP agent to accept SNMP SET requests on certain MIBs, click the Allow SNMP Sets
check box. If this box is not checked, SET requests are rejected.
Step 4 If you want to set up the SNMP proxy feature to allow network management, message reporting, and
performance statistic retrieval across ONS firewalls,click the Enable SNMP Proxy check box located
on the SNMP tab.
Step 5 Click Apply.
Step 6 After clicking either one or both option check boxes, click Create in the Trap Destinations area.
Step 7 Ifyou are only allowing SNMP sets, complete the following in the Create SNMP Trap Destination dialog
box (Figure 4-8):
•Destination IP Address—Typethe IP address of your network management system. If the node you
are logged into is an ENE, set the destination address to the GNE.
•Community—Type the SNMP community name. For a description of SNMP community names,
refer to the SNMP information in the Cisco ONS 15454 SDH Reference Manual.
Purpose This procedure provisions the SNMP parameters so that you can use
SNMP management software with the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
Required/As Needed Required if SNMP is used at your installation.
Onsite/Remote Onsite or remote
Security Level Provisioning or higher