Chapter 2 Cleaning the Optical Array Cable Connectors
How to Clean the Optical Array Cable Connectors
How to Clean the Optical Array Cable Connectors
Each optical array cable connector contains six optical ferrules. To access all ferrules, you must clean three ferrules and then rotate the adapter 180 degrees to clean the remaining three ferrules. This section describes the process to clean all ferrules in an optical array cable.
Warning Because invisible radiation may be emitted from the aperture of the port when no fiber cable is connected, avoid exposure to radiation and do not stare into open apertures. Statement 125
Warning Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 281
Caution Before you begin, review the “General Reminders and Warnings” section on page
To clean the optical array cable connectors, follow these steps:
Step 1 Attach an
Step 2 Attach the adapter, as shown in Figure
Figure
1
2
3
138660
1 | Alignment pin holes on the | 3 | Example of an adapter properly |
| OIM/S13 array adapter |
| installed on an optical array cable |
|
|
|
|
2 | Alignment pins on the optical |
|
|
| array cable |
|
|
|
|
|
|
Step 3 Wrap your hand around the adapter and trunk array to prevent movement during cleaning.
Cisco
| ||
|