Removing the Bezel and Cover
Removing the Bezel and Cover
Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. Statement 1
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046
To remove the bezel and cover, follow these steps:
Step 1 Review the information in the “Protecting Against Electrostatic Discharge” section on page 2.
Step 2 Power down the device and all attached devices. Disconnect the power cord and all external cables. Step 3 Remove the bezel as shown in Figure 1.
a.Press the release tabs on the bezel and pull the bezel away from the chassis.
b.Store the bezel in a safe place.
Figure 1 | Removing the Bezel |
151560
Step 4 To remove the cover, loosen the captive screw (labeled 1 in Figure 2) on the rear of the cover.
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
4 |
| |
|
