Replacing the Cover and Bezel and Completing the Installation
1 | SCSI connector | 2 | Jumper pins |
|
|
|
|
3 | Power connector | 4 | Circuit board facing up |
|
|
|
|
5 | Drive carrier | 6 | Carrier handle |
|
|
|
|
Step 11 Connect the power and SCSI cables to the drive. If you disconnected the IDE cable to the
Step 12 Make sure that your cables are lying flat inside the chassis, so that you do not shear them when you replace the chassis cover.
Replacing the Cover and Bezel and Completing the Installation
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
•This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.
•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006
Warning This unit is intended for installation in restricted access areas. A restricted access area is where access can only be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is controlled by the authority responsible for the location. Statement 37
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
| 9 |
| |
|
|
