Removing and Replacing a SCSI Hard Disk Drive
Figure 4 |
| Hard Disk Drive Connectors and SCSI ID Jumper Pins | |||||
1 | 2 | 3 |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 151557 |
| 4 |
|
|
|
|
|
|
1 | Power connector | 2 | Jumper pins |
|
|
|
|
3 | SCSI connector | 4 | Jumper placement for SCSI ID 1 |
|
|
|
|
Step 2 To check whether the configuration is correct, refer to the boot time messages on the device console. An example is as follows:
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0
Removing and Replacing a SCSI Hard Disk Drive
Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. Statement 1
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Note All hard disk drives that you use in the WAE should have the same throughput speed rating. Mixing hard disk drives with different speed ratings will cause all hard disk drives to operate at the lower throughput speed. Cisco technical support does not support appliances configured with hard disk drives of mixed speed ratings.
Note The
To install a SCSI hard disk drive in the
Step 1 Review the information in the “Protecting Against Electrostatic Discharge” section on page 2. Step 2 Inspect the new drive for any signs of damage.
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
| 7 |
| |
|
|
