50 Cisco Systems Intelligent Gigabit Ethernet Switch Module for the IBM Eserver BladeCenter System Message Guide
%Error:No free masks available This error message means that there are no free masks
available for the user.
You must use one of the user-defined masks that is already
configured. As an alternative, you can free up one of the
masks by removing all the policies that use that mask.
%Error:Invalid sequence - IP protocol ACE
not
allowed after TCP/UDP protocol ACE
This error message means that a Layer 4 (TCP or UDP
protocol) ACE preceded a Layer 3 (IP protocol) ACE.
%Error: Service-Policy is not supported on
EtherChannel interface This error message means that an access group is applied
on an EtherChannel interface.
Access groups can be applied only to Layer 2 physical
interfaces or management VLANs.
%Error:A MAC Access Group exists on this
interface This error message means that a MAC access group was
previously configured on this interface.
Delete the MAC access group by using the no mac access-
group interface configuration command, and re-enter the ip
access-group interface configuration command.
%Error:An IP Access Group exists on this
interface This error message means that an IP access group was
previously configured on this interface.
Delete the IP access group by using the no ip access-
group interface configuration command, and re-enter the
mac access-group interface configuration command.
%Error:Out of Rule Resources This error mess age means that the hardware has run out of
resources.
Re-enter the command with fewer ACEs.
%Error:No free rules on this interface This error message mea ns that the hardware has run out of
resources.
Re-enter the command with fewer ACEs.
%Error:ASIC error This error message means that the hardware has returned
an error and that the command cannot be completed.
%Error:ASIC out of resources This error mess age means that the hardware does not have
sufficient resources to support the user policies.
%Error:Mask/rule entry failure, errcode=XX This error message means that the hardware displays an
unknown error with the specified error code.
%Error:FAILURE to reinsert old ACL This error message means a hardware failure has occurr ed.
Delete the access group, and re-enter the command.
%Error:Max limit reached for number of
ACEs
in ACL :<acl_name>
This error message means that the maximum number of
ACEs in an ACL has been reached.
The ACE cannot be added to the ACL.
%Error:access-list too large to support on
this interface. Check class-map :
[class-map name] and access-list :[acl
name]
This error message means that the access list cannot be
applied on this interface because the interface does not
have sufficient resources to meet the requirement of this
access list.
Re-enter the command with fewer ACEs.
Table 4. Common ACL Error Messages (Continued).
Error Message Explanation and Suggested Solution