Cisco Systems MCU24 manual Press any key to start configuration Main menu, Q Quit Select

Models: MCU24

1 54
Download 54 pages 33.4 Kb
Page 29
Image 29
Press any key to start configuration...

Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU

Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration

The network configuration Main menu appears as follows:

Press any key to start configuration...

Main menu

N: Configure default network port values

P:Change the configuration software password

S:Configure network security level

A:Advanced configuration menu

Q:Quit

Select:

Caution If you do not press a key before the countdown ends, the device continues its initialization and you can only configure the device by pressing the RST button on the front panel.

Step 7 At the prompt, enter N to configure default network port values and press Enter.

Step 8 At the Enter IP address for Interface No. 1 prompt, enter the IP address you want to assign to the Cisco Unified Videoconferencing 3515 MCU unit and press Enter.

Caution Do not use leading zeros in the IP address.

Step 9 At the Enter Default Router IP Address prompt, enter the IP address of the router that you want the Cisco Unified Videoconferencing 3515 MCU unit to use and press Enter.

Caution Do not use leading zeros in the IP address.

Step 10 At the Enter IP Mask (HEX) prompt, enter the subnet mask as follows:

Convert the subnet mask IP address to hexadecimal notation, enter the hexadecimal number at the prompt, and press Enter.

For example, for the subnet mask 255.255.255.0 the hexadecimal value you enter is FFFFFF00.

Note You can use the desktop calculator on your computer to convert the subnet mask ID to hexadecimal notation.

If a subnet mask is not used, press Enter.

After you enter the subnet mask parameter, the unit updates the boot line parameter and reboots.

Step 11 At the network configuration Main menu, enter Q to save your changes and allow the device to complete the boot process.

Caution Configuration of any of the parameters other than N: Configure default network port values may alter the function of the device and should not be performed by an unauthorized person.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1

 

OL-11897-01

2-7

 

 

 

Page 29
Image 29
Cisco Systems MCU24 Press any key to start configuration Main menu, N Configure default network port values, Q Quit Select