Caveats
•CSCsc01221—When downstream test data is sent from the wired endpoint to four wireless clients at different priority levels (voice, video, background, and best effort), the Cisco Aironet 1000 series access points crash.
Workaround: None for this release.
• CSCsc02741—In the bootloader mode, users are unable to exit or return to the main prompt. If users make mistakes while entering values, they cannot quit the step and are unable to go back and change existing values.
Workaround: Reset the system through IOS or power the device off and on if necessary.
•CSCsc02860—When users download the code image to a WiSM for the first time, the WiSM fails to download the new image to flash memory.
Workaround: Download new code images to the WiSM a second time.
•CSCsc03072—Cisco lightweight access points do not always produce complete logs. Workaround: None for this release.
•CSCsc11660—The current country screen is not 100% accurate for all deployment scenarios, which may cause confusion in some instances.
Workaround: None for this release.
•CSCsc14045—VPN passthrough should not be able to be combined with web policy. Workaround: Do not assign VPN passthrough along with web policy.
•CSCsc22084—Error messages and traps are not triggered when a PoE controller with CDP causes Cisco Aironet 1200 series access points to disable their radios.
Workaround: Disabling CDP resolves this issue.
•CSCsc22663—Deleting a mobility member mapped to a controller as an anchor removes the anchor’s entry as well, but the Auto Anchor knob remains enabled even though only the mobility anchor mapping is deleted.
Workaround: Before deleting a mobility member, first delete the controller to which it is mapped from the WLAN.
•CSCsc35784—The transmit power control adjustment levels 3, 4, and 5 are not supported on Cisco Aironet 1500 Series Lightweight Outdoor Access Points in the 5745-to-5825-MHz band. The transmit power control adjustment levels 4 and 5 are not supported on Cisco Aironet 1500 series access points that operate in the 5500-to-5700-MHz band and at 2.4 GHz.
These levels correspond to -6, -9, and (in the case of 5500 to 5700 MHz) -12 dB from the maximum power, respectively. Power levels 1, 2, and (in the case of 5500 to 5700 MHz) 3 are supported, which correspond to maximum power for the particular data rate and channel, and -3 dB relative to this maximum, at which these adjustment levels provide little or no further reduction in transmit power output.
Workaround: Set the transmit power level to either 1 or 2 for 5745 to 5825 MHz. Set the transmit power level to either 1, 2, or 3 for all other bands.
•CSCsc40648—Rooftop access points are displayed in the web interface as poletop access points for more than four minutes, which prevents them from being configured.
Workaround: Configure the access point as a rooftop access point using the controller CLI.
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.171.6
