Caveats
•CSCse30514—When an LWAPP-enabled AP1100 or AP1200 first connects to a controller, the secondary controller name on the All APs > Details page in the controller GUI is not blank. The output of the show ap config general command also shows that the secondary controller name is not blank.
Workaround: None at this time.
•CSCse30696—The controller does not refresh the access point’s IP address correctly when the admin status for that access point is disabled.
Workaround: None at this time.
•CSCse32656—The 4402 controller supports an enhanced security module (ESM) card only in slot 1, not in slot 2. Slot 2 is reserved for 4404 controllers.
Workaround: Use slot 1, which is the slot closest to the power outlet, for an ESM card in the 4402 controller.
•CSCse40636—The foreign controller incorrectly forwards multicast traffic onto the auto-anchor WLAN.
Workaround: Configure the WLAN on the foreign controller to map to an invalid VLAN.
•CSCse52143—IPSec authentication with certificates may not always operate properly. Workaround: None at this time.
•CSCse60689—The controller may reboot due to a failure with the sshpmAddIPv4IpsecRules software.
Workaround: None at this time.
•CSCse72413—The controller may reboot due to a failure with the debugMaintask software. Workaround: None at this time.
•CSCse80636—Under heavy traffic conditions, the VPN module may reach capacity and fail to accept additional packets.
Workaround: None at this time.
•CSCsf10167—The controller may reboot due to a failure with the pemReceiveTask software watchdog.
Workaround: None at this time.
•CSCsf11862—Controllers sometimes reboot during a software upgrade.
Workaround: Download the software image twice. On the second try, the controller successfully loads the new image.
•CSCsg10391—When you use the remote-debug enable command on the controller CLI to enable remote debugging on an access point, debugging stops when your CLI session times out.
Workaround: Open a new CLI session, disable remote debugging (enter remote-debug disable), and re-enable remote debugging.
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.171.6
