Cisco Systems OL-21636-01 Managing a FlexUNI/EVC ATM-Ethernet Interworking Service Request

CHAP TER

6-1

Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0

OL-21636-01

Managing a FlexUNI/EVC ATM-Ethernet Interworking Service Request

This chapter provides information on how to provision a FlexUNI/EVC ATM-Ethernet Interworking

service request. It contains the following sec tions:

• Overview, page 6-1

• Creating a FlexUNI/EVC ATM-Ethernet Interworking Service Request, page 6-2

• Setting the Service Request Details, page 6-3

• Modifying the FlexUNI/EVC Service Request, page 6-2 3

• Using Templates and Data Files with a FlexUNI/EVC Service Request, page 6-24

• Saving the FlexUNI/EVC Service Request, page 6-24

Overview

A FlexUNI/EVC ATM-Ethernet Interworking service request allows you to configure interfaces on an

N-PE to support the FlexUNI/EVC features described in Chapter 5, “Creating a FlexUNI/EVC

ATM-Ethernet Interworking Policy.” To create a FlexUNI/EVC ATM-Ethernet Interworking service

request, a FlexUNI/EVC ATM-Ethernet Interworking service policy must already be defined, as

described in Chapter 5, “Creating a FlexUNI/EVC ATM-Ethernet Interworking Poli cy.” Based on the

predefined FlexUNI/EVC policy, an operator creates a FlexUNI/EVC service request, with or without

modifications to the policy, and deploys the service. One or more templates can also be associated to the

N-PE as part of the service request.

ATM-Ethernet interworking is supported through the following configurations:

• ATM Tra ns po rt M od e (V C)

–

ATM-Ethernet Pseudowire

–

ATM-ATM Local connect

–

ATM-Ethernet Local connect

• ATM Tra ns po rt M od e (V P)

–

ATM-ATM Local connect

The following steps are involved in creating a FlexUNI/EVC ATM-Ethernet Interworking service

request:

• Choose an existing FlexUNI/EVC ATM-Ethernet Interworking policy.