Cisco Systems OL-9977-05 manual Adjustment Plate Attached to the Mounting Plate

Chapter 2 Mounting Instructions

Mounting the Access Point

C i s c o C o n f i d e n t i a l - D r a ft 1

Step 1 From the pole mount kit, use four of the supplied short bolts, lock washers, and flat washers to attach the pole mount kit adjustment plate to the access point mounting plate as shown in Figure 2-8. Tighten the bolts to 15 to 20 ft. lbs. (20 to 27 Nm).

Figure 2-8 Adjustment Plate Attached to the Mounting Plate

142686

Step 2 Select a mounting location. You can attach the access point to any pole from 1.66 to 3.35 in. (4.22 to 9.02 cm) in diameter.

Note If you will be using a streetlight power tap adapter, position the access point within 3 ft (1 m) of the outdoor light control.

Step 3 Loosely assemble the pole clamp components around the pole and thread the four long bolts into the clamp adjustment plate. Figure 2-9shows the pole clamp attached to a pole with the clamp adjustment plate positioned on the bolts.

Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide

2-18 OL-9977-05