1-8
Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-9977-05
Chapter 1 Overview
Network Configuration Examples
Point-to-Multipoint BridgingThe access points can be used as a RAP to connect multiple remote MAPs with their associated wired
networks (see Figure 1-4). By default this capability is turned-off for all access points. To support
Ethernet bridging, you must enable bridging on the controller for each access point.
Wireless client access can be provided over the bridging link; however, if bridging between tall
buildings, the 2.4-Ghz wireless coverage area may be limited and possibly not suitable for direct wirele ss
client access.
Figure 1-4 Access Point Point to Multipoint Bridging Example
Mesh NetworkThe access points are typically deployed in a mesh network configuration. In a typical mesh deploymen t,
one or more RAPs have a wired network connection through a switch to a controller. Other remote MAPs
without wired network connections use the backhaul feature to optimally link to a RA P that is connected
to the wired network. In the mesh network, the links between the access points are referred to as the
backhaul links.
Intelligent wireless routing is provided by the patent-pending Adaptive Wireless Pa th protocol (AWPP).
This enables each MAP to identify its neighbors and intelligently choo se the op timal pa th to t he RA P
with the wired network connection by calculating the cost of each path in terms of signal strength and
the number of hops required to get to a controller.
148439