Golden Technologies GP160 owner manual Arm Width Adjustment, Armrest Angle Adjustment

LiteRider PTC_Owner’s Manual Rev A_121911

VI. COMFORT SETTINGS

Arm Width Adjustment

1.Loosen the adjustment screw at the rear of the seat with a 4mm Allen wrench. See figure 9.

2.Slide the arm in or out to the desired width.

3.Tighten the adjustment screw to secure the arm.

4.Repeat steps 1-3 to adjust the opposite arm.

Figure 9

Note: The backrest can be folded down to minimize chair height during transport.

Armrest Angle Adjustment

1.Lift armrest up. See figure 10.

2.Turn jam nut counter-clockwise to loosen.

3.Turn the adjustment bolt using a 5mm Allen wrench to raise or lower the armrest- angle. Turning the bolt counter-clockwise will raise the angle. Turning the bolt clockwise will lower the angle. Turn until desired angle is reached.

4.Re-tighten jam nut by turning clockwise.

5.Repeat steps 1-4 on the opposite armrest.

Adjustment Bolt

(5mm Allen)

Jam Nut (14mm)

Figure 10

18